Stacker Control Panel - IBM INFO PRINT 3000 Operator's Manual

Stacker Control Panel

The stacker control panel is just above the stacker. The controls allow you to raise
and lower the stacker table, stop the movement of the stacker table, advance the
forms, and select the type of form being used. The panel also indicates with lights
the length of the forms being used, which is set by the Forms Length Control (see
"Forms Length and Width Controls" on page 30).
Figure 2. Stacker Control Panel
Using This Control:
28
InfoPrint 3000 Operator's Guide
Forms
Table
Feed
Up
Forward
STOP READY
Down Stop
Forms Select
A 16-22 lbs(51-71kg)60-82g
B 23-42 lbs(72-135kg)83-157g
C Plastic
Forms Length
8 9 10 11 12 13 14
7
0 1/3 1/2 2/3
Does This:
Makes the complete system (both printers) Ready when the
printing system is in duplex mode, or makes the individual printer
Ready when the system is in dual simplex mode. If pages are
waiting to be printed and the system or printer is online to the
host, printing begins.
Finishes the page that is currently being printed and makes the
printing system (both printers) Not Ready in duplex mode or the
individual printer Not Ready in simplex mode.