Table of Contents
Advertisement
Unloading the Stacker
Do this task when you need to remove printed forms from the stacker or when
you see the following message:
Some controls you need to use to accomplish this task are available only on the
stacker control panel, and some are available on the Display Touch Screen window.
STACKER FULL 0796
1. If you need to stop the printer, SELECT the Stop pushbutton on the Display
Touch Screen window.
2. If you need to remove all the current forms from the forms path, separate the
forms at a perforation below the transfer station. Ensure that the end-of-forms
sensors are uncovered. Open the static brush so the forms fall back into the
box or input area.
3. If you need to move forms to the stacker, SELECT the NPRO pushbutton on
the Display Touch Screen window.
If END OF FORMS appears, repeat this step again.
Forms
Table
Feed
Up
Forward
READY
STOP
Down
Stop
Forms Select
A 16-22 lbs(51-71kg)60-82g
B 23-42 lbs(72-135kg)83-157g
C Plastic
Forms Length
7
8
9
10
11
12
0
1/3
1/2
4. On the stacker control panel, press the stacker table Down switch and wait for
the stacker table to stop moving.
13
14
2/3
Chapter 6. Operator Responsibilities
169
Advertisement
Table of Contents
