Table of Contents
Advertisement
– The system has gone through a "Restart" procedure with forms that are
loaded through both printers.
– You are in a recovery procedure for an error condition or a forms jam that
did not tear, damage, or separate the forms in the forms path through
both printers.
– The system power was switched off and then switched back on with
unseparated forms threaded through both printers.
v Forms are not loaded in printer 2:
Select this when:
– You are loading a new type of form with different characteristics from the
last form that you used in the system.
– You are loading the same type of form that you previously used in the
system; it was allowed to run out to end-of-forms; and it was flushed out
of the printer so that a new supply of forms could not be spliced to the
trailing edge of the old supply.
– You are in a forms jam recovery procedure that separated the forms in a
manner that you could not rejoin by splicing.
v Forms are broken between the printers:
Select this when you are recovering from a condition that separated the
forms between Printer 1 and Printer 2 that you can rejoin by splicing.
2. If you SELECT the Cancel pushbutton on the window, the following actions
occur:
v If you selected this procedure from the Operate pull-down menu, the
Thread/Align Forms procedure closes with no actions taken.
v If this procedure appeared automatically, the Thread/Align Forms procedure
closes. However, any later attempt to make the printer Ready causes an
Intervention Required Display Touch Screen window containing a "D206"
SRC to appear. This requires SELECTING the Thread/Align Forms
procedure and executing it before any printing actions can resume.
Chapter 6. Operator Responsibilities
153
Advertisement
Table of Contents
