Forms Length and Width Controls
Using This Control:
30
InfoPrint 3000 Operator's Guide
Does This:
FORMS WIDTH
Increases or decreases the stacker width setting. You can set this
lever from 8 to 18 inches in increments of ¼ inch.
1
FORMS LENGTH
Increases or decreases the stacker length setting. You can set the
forms length from 7 to 14 inches. The length increases or decreases
2
in increments of one-third and one-half inch. You turn the knob
clockwise to increase the forms length. You turn the knob
counterclockwise to decrease the forms length.
The length you set with the FORMS LENGTH knob is indicated by
the LEDs on the Stacker Control Panel.