Checking the Fine Filter
Do this task when you see the following message:
Note: You must do this task immediately. You cannot delay it as you can with
1. From the rear of the printer, open the rear center cover.
2. Ensure that the filter container is upright in the recessed filter area.
3. Ensure that the filter cover is firmly latched in place.
4. Ensure that the filter hose is attached to the filter cover.
5. Close the rear center cover of the printer.
6. To resume processing, SELECT the Ready pushbutton on the main Display
7. If the CHECK FINE FILTER message appears again, repeat steps 2 through 6. If
200
InfoPrint 3000 Operator's Guide
CHECK FINE FILTER 0799
some Out of Supplies conditions.
Touch Screen.
that still does not correct the problem, contact your service representative. See
"Service Call Procedure" on page 13 for instructions.