Loading Forms (Simplex Or Dual Simplex Mode) - IBM INFO PRINT 3000 Operator's Manual

Loading Forms (Simplex or Dual Simplex Mode)

Do this task when any of the following situations occur:
v When you see the END OF FORMS 078A message
v You need to change forms
v When you are prompted by a forms jam recovery procedure step.
This section provides step-by-step instructions for loading forms in a Model ES1
printer or Models ED1/ED2 in dual simplex mode. "Loading Forms (Duplex
Mode)" on page 115 contains instructions for loading form in an ED1/ED2 printing
system in duplex mode. These instructions are for loading boxed, continuous forms
that are loaded at the forms input area.
If preprocessing or postprocessing devices, or both, are used with the printing
system, steps involving the continuous forms source or the final destination are
different from the instructions given here. Because each preprocessing or
postprocessing device is unique, you should use the specific instructions for the
initial loading from a preprocessing device to the printer or forms handling in a
postprocessing device following the printer that accompany the preprocessing or
postprocessing device.
102
InfoPrint 3000 Operator's Guide