Mounting The Pc Board - Honeywell ADEMCO VISTA-12A Installation And Setup Manual

Installation and Setup Guide

Mounting the PC Board

NOTE: The door of the metal cabinet may be
removed to make it easier to install the PC board.
Remove the door as follows:
1. With the cabinet laying on a flat surface,
swing open the door to its full-open position.
2. Slide the door out of its retaining slots in the
cabinet and store in a safe place.
3. Remove standoff (part number K0380) from
the hardware bag and insert it into the square
hole in the back of the cabinet so that it will
align behind the lower left mounting hole in
the PC board.
2-2
4. Insert top of circuit board into slots at top of
cabinet. Make sure that circuit board rests in
slots as indicated in the diagram shown
below.
5. Swing base of circuit board onto the raised
cabinet tab and standoff.
6. Secure the sides of the PC board to the
enclosure using the 2 screws provided.
Notes
• Before installing the cabinet's contents, remove
the metal cabinet knockouts required for
wiring entry. Do not remove the knockouts
after the circuit board has been installed.
1 3 4 5 6 7 8 9 10 11 12 13 14 15
Figure 2. Mounting the PC Board
16 17 21 22 23 25
V12D-001-V0