Mercantile Safe And Vault Listing Guidelines; Installing The Control's Circuit Board; Figure 3: Cabinet Attack Resistance Considerations; Figure 4: Mounting The Pc Board - Honeywell VISTA-128BPT Installation And Setup Manual

VISTA-128BPT/128BPT-SIA/250BPT INSTALLATION AND SETUP GUIDE

Mercantile Safe and Vault Listing Guidelines

• Follow the guidelines given above for Mercantile Premises listing.
• Mount a shock sensor such as the System Sensor ASC-SS1 to the control's back box. Follow the manufacturer's
instructions for proper sensor mounting. This sensor also must be wired to a hardwire zone.
• For safe and vault applications, a UL Listed contact must be used inside the cabinet through one of the
knockouts for pry-off tamper purposes. This sensor also must be wired to a hardwire zone.

Installing the Control's Circuit Board

Hang the three mounting clips on the raised cabinet tabs. Refer to Figure 4 (Detail B).
1.
Make sure the clip orientation is exactly as shown in the diagram to avoid damage. This will also avoid
problems with insertion and removal of the PC board.
Insert the top of the circuit board into the slots at the top of the cabinet. Make certain that the board rests
2.
in the slots as indicated (Detail A).
Swing the base of the board into the mounting clips and secure the board to the cabinet with the
3.
accompanying screws.
NOTES:
• Make certain that the
mounting screws are tight.
This ensures that there is a
good ground connection
between the PC board and
the cabinet.
• Dress field wiring away from
the microprocessor (center)
section of the PC board. Use
the loops on the left and
right sidewalls of the cabinet
for anchoring field wiring
using tie wraps (Detail C).
These steps are important to
minimize the risk of panel RF
interference with television
reception.

Figure 3: Cabinet Attack Resistance Considerations.

Figure 4: Mounting the PC Board

4-2