Honeywell ADEMCO VISTA-12A Installation And Setup Manual page 81

Hide thumbs Also See for ADEMCO VISTA-12A:
Table of Contents

Advertisement

PROMPT
S T A R T
S M T W T F S
0 0 1 0 0 0 0
H H M M A M
W A R N I N G D L Y T I M E
0 0
S T O P
S M T W T F S
0 0 1 0 0 0 0
H H M M A M
R E P E A T O P T I O N
0 - 4
X
R A N D O M I Z E
0 = N O 1 = Y E S
X
VALID ENTRIES
Start Time
01-12 (00-23)
= hour
00-59 = minute
0 = AM; 1 = PM (if applicable)
Days = place "1" under days
[∗] to continue
Warning Delay Time
01-15 = arm warning delay time
in minutes
[∗] to continue
Stop Time
01-12 (00-23)
= hour
00-59 = minute
0 = AM; 1 = PM (if applicable)
Days = place "1" under days
[∗] to continue
Repeat Option
0 = do not repeat
1 = repeat schedule weekly
2 = repeat schedule biweekly
(every other week)
3 = repeat schedule every third
week
4 = repeat schedule every fourth
week
[∗] to continue
Randomize
0 = no
1 = yes
[∗] to continue
EXPLANATION
Enter the event's start time and days of the week
to occur.
To select days, position the cursor under the
desired days using the [∗] key to move forward,
then press "1" to select the day(s).
† use 00-23 if 24-hour time is enabled.
This prompt appears if events "4 or 5" were
selected.
Enter the desired amount of time the system
should warn of impending arming. The system
will beep once every 30 seconds to alert users
that arming will soon occur. Otherwise, this
prompt is skipped.
Enter the event's stop time and days of the week
to occur.
To select days, position the cursor under the
desired days using the [∗] key to move forward,
then press "1" to select the day(s).
This entry applies only to the following events:
1 (relay on/off)
2 (user access)
3 (child-not-home report)
† use 00-23 if 24-hour time is enabled.
Enter the desired repeat option for this schedule.
e.g., To make a schedule that happens everyday
you would select all days with a repeat count of
1. To make a schedule that runs for one week
then stops, select everyday with a repeat count of
0.
NOTE: Schedules run sequentially from Sunday
to Saturday and reset on Sunday at midnight. If
repeat count is 0, only those events scheduled
from the day the schedule is set to Sunday will
occur. Events scheduled after Sunday will be
ignored.
If selected, the scheduled start and stop times
will vary within 60 minutes of the "hour" time.
For example, if a schedule is set to start at
6:15pm, it will do so the first time 6:15pm
arrives, but on subsequent days it will start
anytime between 6:00 and 6:59 p.m.
NOTE: Do not use the random option if the start
and stop times are within the same "hour" setting,
otherwise unpredictable results may occur (e.g.,
the randomized stop time may occur before the
start time).
Testing the System
5-25

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ademco vista-12e

Table of Contents