Honeywell ADEMCO VISTA-12A Installation And Setup Manual page 94

Installation and Setup Guide
Various System Trouble Displays
Busy-Standby
Modem Comm
no display
Comm. Failure
Open Circuit
Long Rng Trbl
Bell Failure
RCVR Jam
KEYPAD LOW BAT
Phone Okay
Dialer Off
Test in Progress
Upload Completed
Upload Failed dF The upload or download session failed before completion.
6-12
(cont'd)
If this remains displayed for more than 1 minute, the system is
dl
disabled.
CC The system is in communication with the central station for
change of function or status verification.
Power Failure
no display
If there is no keypad display at all and the LEDs are unlit,
operating power (AC and battery) for the system has stopped and
the system is inoperative.
If the message "AC LOSS" (Alpha display keypads) or "NO AC"
(Fixed-Word display keypads) is displayed, the keypad is
operating on battery power only.
If the battery standby capacity is used up during a prolonged AC
power outage, the control's power will shut down to minimize deep
discharge of the battery.
The display may also be blanked intentionally (except during exit
delay and for 30 seconds after disarming, or during a mains power
loss) if field *186 Display Options entry 2 is enabled.
A communication failure has occurred.
FC
OC The keypad is not receiving signals from the control and sees an
open circuit.
bF Backup Alternative Communication Media communication failure.
70 Siren supervision failure.
90 RF jam detected.
Wireless keypad low battery
00 BAT
Cd The dialer test has been successful (CID code 601).
The dialer is disabled.
dO
dd Walk test mode is active(CID code 607).
dC The upload or download session was completed.