Honeywell ADEMCO VISTA-12A Installation And Setup Manual page 71

PROMPT
01 A E P Trig
?00 0 0 – ZL=1
01 Activated By:
Zone List
"A"
01 Zn List
1
VALID ENTRIES
Summary Screen
[∗] to continue
Activated By
0 = delete
1 = zone list
2 = zone type
3 = zone number
[∗] to continue
Zone List
01-12 = zone list
[∗] to continue
Menu Mode Programming
EXPLANATION
This screen displays a summary of the current
output programming (for this example, Zone List
has been selected-this is the default screen).
A = Output Action; E = Triggering event; P =
Partition; Trig = Trigger type
NOTE: A question mark in the summary screen
indicates that the device number shown has not
been mapped. Use *79 Menu mode to map the
device.
Select where the initiating event for this output
definition is to occur as follows:
0 = delete (deletes the output function and any
previous programming;-see prompt below)
1 = zone list (go to "A" prompt)
2 = zone type (go to "B" prompt)
3 = zone number (go to "C" prompt)
If you enter "0," the following prompt appears:
Delete?
0 = NO, 1 = YES
If zone list was selected, this screen appears.
Otherwise skip to the next row.
Enter the desired zone list number associated
with this output number.
NOTE: Zone lists 09-12 can be used in output
definitions if not used for paging or for exit zone
definition.
Press [ ∗ ] to continue.
Enter the zone list event that will activate this
output.
Enter Event
Alarm 11
NOTE: For alarm, fault, and trouble, an event on
ANY zone in the list activates the output.
Press [ ∗ ] to continue and skip to the "Output
Action" prompt.
Press 1 to delete this
output definition.
0 = restore; 1 = alarm;
2 = fault; 3= trouble
5-15