Honeywell ADEMCO VISTA-12A Installation And Setup Manual page 72

Installation and Setup Guide
PROMPT
"B"
01 Enter Zn type
Perimeter 03
5-16
VALID EXPLANATION
ENTRIES
Zone Type If zone type was selected, this screen appears. Otherwise skip to
the next row.
see list at right
Enter the desired zone type associated with this output number.
See below for a list of available zone types.
CHOICES FOR ZONE TYPES:
00 = Not Used
01 = Ent/Exit #1
02 = Ent/Exit #2
03 = Perimeter
04 = Interior Follower 09 = Fire
CHOICES FOR SYSTEM OPERATION:
20 = Arming–Stay
21 = Arming–Away
22 = Disarming
31 = End of Exit Time
32 = Start of Entry Time
33 = Any Burglary Alarm
36 = **At Siren Timeout***
38 = Chime
39 = Any Fire Alarm
40 = Bypassing
** Use 0 (Any) for Partition No. (P) entry.
*** Or at Disarming, whichever occurs earlier.
† Use *57 Menu Mode to assign the function key (function "07").
Note: In normal operation mode:
Code + # + 7 + NN Key Entry starts Device NN.
Code + # + 8 + NN Key Entry stops Device NN.
Enter the partition in which this zone type will occur.
01 Partition
Any partition
Press [ ∗ ] to continue and skip to the "Output Action" prompt.
05 = Trouble Day/Alarm Night 15 = Medical
06 = 24 Hr Silent
07 = 24 Hr Audible
08 = 24 Hr Aux
10 = Interior w/Delay
12 = Monitor Zone
14 = Gas
41 = **AC Mains Failure 67 = Siren Fail
42 = **System Batt Low
43 = Comm. Failure
46 = Sys Batt Restore**
52 = Kissoff
54 = Fire Zone Reset
58 = Duress
60 = AAV
66 = Function Key†
0 = any partition; 1 = partition 1;
0 2 = partition 2;
16 = Fire w/verification
23 = No Alarm Response
24 = Silent Burglary
77 = Keyswitch
81 = AAV Monitor Zone
82 = Blockschloss
90-93 = Configurable
68 = Telecom Line Cut
69 = Telecom Line
Rstore
70 = AC Mains Restore**
71 = System Startup/
Clock Not
Set
72 = Clock Set
78 = Keyswitch Red LED
79 = Keyswitch Green
LED
80 = Tamper Fault
3 = partition 3