Completing Zone Programming - Honeywell ADEMCO VISTA-12A Installation And Setup Manual

PROMPT
XMIT TO CONFIRM
✱
PRESS TO SKIP
Zn ZT RC In: L
17 03 10 RF: 1s
PROGRAM ALPHA?
0 = NO 1 = YES 0
E N TE R Z N N U M .
( 0 0 = Q U I T ) 1 1

Completing Zone Programming

When you have finished programming all zones, test each zone using the system's TEST mode. Do not
use the Sensor Sniffer Mode for checking wireless transmitting devices, as it will only check for
transmission of one zone on a particular transmitter, NOT the zones assigned to each additional loop.
NOTE: Following the successful enrollment of each wireless device, note the device serial number in
the appropriate column on the ENROLLED TRANSMITTERS worksheet in the Programming Form;
then enter the other information (zone number, zone type, loop number, etc.) relevant to that device.
VALID ENTRIES
Confirmation Option
Activate the loop input or button
[∗] to continue
Summary Screen
[∗] to continue
Alpha Descriptors
0 = no
1 = yes
[∗] to continue
Next Zone Number
00 = quit
[∗] to continue
Menu Mode Programming
EXPLANATION
This prompt will only appear if you answered
"Yes" at the first prompt in this section.
The system will enter a confirmation mode so that
the operation of the actual programmed input can
be confirmed.
Activate the loop input or button that corresponds
to this zone.
If the serial number and/or loop number
transmitted does not match the serial number
entered, a display similar to the one below appears.
E n t d A 0 2 2 - 4 0 6 3 1
R c v d A 0 2 2 - 4 0 6 4 1
If so, activate the loop input or button on the
transmitter once again. If a match is not obtained
(i.e., summary display does not appear), press the
[#] key twice and then enter (or transmit) the
correct serial number.
Press [∗] to continue.
If the serial number transmitted matches
the serial number entered, the keypad will
beep 3 times and a summary display will
appear, showing that zone's programming.
Note that an "s" indicates that a
transmitter's serial number has been
enrolled.
Press [∗] to accept the zone information and
continue.
If you want to program descriptors for zones now,
enter 1 (Yes) and refer to the Alpha Descriptor
Programming section for the procedure to use.
If 0 (No) was entered above, the system will
return you to the ENTER ZN NUM. prompt for
the next zone.
When all zones have been programmed, enter 00
to quit.
5-5