Pager Programming Fields - Honeywell ADEMCO VISTA-12A Installation And Setup Manual

FIELD TITLE and DATA ENTRIES
Download Phone Number
*94
Enter up to 30 digits as follows: 0–9, # +11 for "∗", #
+ 12 for "#", # + 13 for a pause.
Ring Count For Downloading
*95
0 = Disable Monitoring Station initiated downloading
1–14 = number of rings before control answers
incoming call
#+15 = Answering machine/fax defeat

Pager Programming Fields

FIELD TITLE and DATA ENTRIES
Pager 1 Phone No.
*160
Enter up to 20 digits
Data Field Programming
EXPLANATION
Enter the phone number of the downloading
computer.
Do not fill unused spaces. End field by entering ∗.
To clear entries from field, press ∗94∗.
Refer to the chart below and program this field
accordingly.
phone answer/fax down-
module machine loading
yes no no
yes yes no
yes no yes
yes yes yes
no no no
no yes no
no no yes
no yes yes
† NOTE: If "15" is entered to bypass an answering
machine and a TeleCommand Phone Module is included
in the system, you should note the following:
When calling in from an off-premises phone, the user
should make the initial call, allow 1 or 2 rings only, then
hang up, then call again. The phone module will now
seize the line, and 2 long tones sound, followed by the
usual voice prompt for the access code. If this procedure is
not followed, phone module operation will not be possible.
EXPLANATION
If you enter fewer than 20 digits, exit by pressing
[∗] and next field number. To clear entries from
this field, press ∗160∗.
Set field ∗ ∗ ∗ ∗ 95 to...
1-14 (not 0)
higher than
number of rings
set on answer/fax
machine (e.g., if
ans/fax machine is
4 rings, set this
field to 5). This
allows access via
the phone module
if the answer/fax
machine is turned
off.
1-14 (not 0)
15 (bypasses
answer/fax
machine † )
0
0
1-14
15
4-13