System Flags Programming; Initial Programming Of System Flags; System Flags Correction; System Flags Values Print Out - ELCOM Euro-200TE User Manual

Programming manual

SYSTEM FLAGS PROGRAMMING

Prior to programming of the cash register, it is recommended that this subchapter is carefully studied and
clearly understood.
Note: If a key is used for two functions, choose the function in a lower part of a key by pressing the key. To
choose the function in the upper part of a key, press the
 key is working in sticky shift mode.

Initial programming of system flags

The system flags represent settings that have primary influence on the proper performance of cash register
(number of decimal places, rounding, date, time, etc.).
System flags programming procedure:
1) Switch the cash register into the "P" mode by pressing
bottom on the display). Only a cashier authorised for the programming mode can set the cash re-
gister into the "P" mode.

2) Press
3) After entering flag values, store them by pressing the
the next flag follows. Continue until you have programmed all necessary flags.
4) Finish flags programming by pressing the

System flags correction


1) To change the settings of any system flags, switch the cash register into the "P" mode by pressing
.
2) Enter the flag number to be edited and press the
3) Enter desired flag value and press the
4) Print the new programmed settings by pressing the
5) Finish the programming by pressing the

System flags values print out


In the programming mode, select the flags programming by pressing the

(Check) button to print the flags values. It is possible to print the value of currently programmed flag by
pressing the (EAN) button.
30
, or use the Menu in P mode.
301222
SF1:

(Shift) key and press the particular key. The


(Subtotal) button. The programming of

(Total) button.


(RA) buttons.

(Subtotal) button.

(Check) button.
(Total) button.
. On the display appears „

(RA) buttons. Press the
P
" (left