Cashiers Programming - ELCOM Euro-200TE User Manual

Programming manual

CASHIERS PROGRAMMING

The programming of cashiers consists of four steps:
• cashier's name
• cashier's password
• cashier's access rights
• cashier's access to operations
The cash register allows you to program up to six cashiers. This programming allows you to assign a
password to each cashier, which will be used by him/her to log into the cash register and use its functions.
This password will also identify the cashier working on the cash register: the receipts issued by that cashier
are identified by his/her name and all operations are assigned to him/her.
Programming procedure:

1) Switch the cash register to the "P" mode by pressing
2) Press the
in the second display row which indicates that you are programming the cashier's name. First dis-
play row contains the current cashier's programmed name.
3) Enter the name for the current cashier. Cashier name can have up to ten characters. If you mistype
or make a mistake while entering text, you can use the
See the end of the chapter for hints on entering texts.
1
4) Finish the cashier name programming by pressing
rent cashier number in the second display row, together with the label ("
gramming of cashier's password. Press
not run).
1
5) Enter the cashier's password. The password is composed by the up to four numerals. If you mistype
during entering of the password, you can use
6) Finish the programming of cashier's password by pressing
will then show the current cashier number in the second display row along with label ("
that indicates programming of cashier's access rights for cash register modes. Press
to finish the entire programming procedure (next steps will not run).
1

7) Program the mode access flags according to the Figure 3.19. If you mistype, correct your mistakes
using (C
number 1.
40
(P ) key. Display will show the current cashier number and label ("
ASSWORD
KASSÖR1
KASS.NAMN
KASS.LÖSEN
KASS.BEHÖR
) key.Warning: you cannot deny access to programming mode "P" for the cashier
LEAR



(S
UBTOTAL

(T ) to finish the programming procedure (next steps will
OTAL
0001

(C ) key to correct your mistakes.
LEAR
1111
.
(C ) key to delete recent characters.
LEAR
) key. The cash register shows the cur-
PASSW
") that indicates pro-

(S ) key. The cash register
UBTOTAL
NAME
")

ACCESS
")
(T )
OTAL