Initialisation; Recommended Procedure For Euro-200T/Tx Programming; System Flags Programming; Initial Programming Of System Flags - ELCOM Euro-200T User Manual

Programming manual

INITIALISATION

Before putting the cash register into operation, it must be initialised. The cash register initialisation clears all
programmed data and will return the ECR to default settings. Only following data will be preserved: grand
totals, report numbers (Z1 and Z2) and value of system flag no. 1. ECR initialisation is possible only if daily
and periodical reports have been issued in "Z" mode.
Initialisation procedure:
1) Turn the cash register on and press
enter "P" mode.

2) Press button. The "
ring
" label appears on the display.
3) To confirm the initialisation, press the
(Subtotal) button. The ECR printer prints
Memory clearing
"
4) After initialisation enter the date (DDMMYY)
and time (HHMM).

RECOMMENDED PROCEDURE FOR EURO-200T/TX PROGRAMMING

The recommended procedure for ECR programming advises an user to program the ECR in the following
order: 1) system flags, 2) tax levels, 3) extended flags 4) receipt logo, 5) cashiers, 6) function texts, 7)
partments, 8) sale units and finally 9) article items (PLUs).

SYSTEM FLAGS PROGRAMMING

Prior to programming of the ECR, it is recommended that this subchapter is carefully studied and clearly
understood.
Note: If a key is used for two functions, choose the function in a lower part of a key by pressing the key. To
choose the function in the upper part of a key, hold the

Initial programming of system flags

The system flags represent settings that have primary influence on the proper performance of ECR (number
of decimal places, rounding, date, time, etc.).
System flags programming procedure:
1) Switch the cash register into the "P" mode by pressing
bottom on the display). Only a cashier
rised for the programming mode can set the
ECR into the "P" mode.

2) Press
3) After entering flag values, store them by pressing the
the next flag follows. Continue until you have programmed all necessary flags.
4) Finish flags programming by pressing the
26

Memory
" and it begins the initialisation.
(RA) buttons.
to
P
clea-
P


(Shift) key and press the particular key.

autho-


(Total) button.
02-02-2005
19:05:33
MEMORY CLEARING
10:21:09
ENTER DATE
ENTER TIME
. On the display appears „
SF1:
(Subtotal) button. The programming of
de-
P
" (left
301112