Table of Contents
Advertisement
Failures of cash register as a result of interference in power network
Accidental failures of electronic equipment are frequently caused by the power network or by electromag-
netic interference. In case of intensive interference in your working area, or in case of over or under voltage,
installation of protective devices can help significantly. Ask your authorised dealer or service technician for
help.
Signalization of internal accumulator conditions
The status of internal accumulator charge defines the percentage value in the upper left corner of the
cashier display. This percentage value informs also that power supply of the cash register is internal accu-
mulator (the external adapter is not connected). In the case the charge is low (low percentage value) the
cash register displays the text Low BAT., finish sale for a short time and peeps alerting tone.
If the internal accumulator is very discharged and you want to charge it by the external adaptor, first of all be
sure that cash register is turned off, then connect the external adapter for at least 15 minutes (ECR is off).
The internal accumulator is charging even the cash register is turned off.
Care of internal battery:
•
a complete battery charge takes 8 hours.
•
we suggest to charge a battery to 100 % and use it till cash register starts to signalize the battery char-
ge requirement. Repeat this process three times at least (it elongates an endurance of the battery).
•
we suggest to change the battery in case of the battery decrease, e. g. shorter work cycle of the
cash register after a battery charge.
SELF TESTS
Self tests of the Euro-200TE cash register permit the checking of its functionality simply and quickly. Self
testing permits the automatic checking of the functionality of electronic circuits, display segments, keyboard
buttons, communication ports and the printer.
Self-test of the electronics and display
By executing this test, characters are gradually lightened on and off on the both displays.
Procedure for running the self-test of the electronics and display:
Customer display:
1) Switch the cash register into the "P" mode:
2) Press
3) Press the
Cashier display:
1) Switch the cash register into the "P" mode:
2) Press
3) Press the
Display test end is announced by a beep. You can continue testing other parts of register.
on the keyboard.
(M
) button.
ULTIPLY
on the keyboard.
(M
) button.
ULTIPLY
.
.
Helpful advice
111
Advertisement
Table of Contents
Need help?
Do you have a question about the Euro-200TE and is the answer not in the manual?