Entering Texts Into The Electronic Cash Register - ELCOM Euro-200TE User Manual


4) Enter the 3-character currency code (–e.g., USD); save this value and move to the next setting by pres-
sing the key
5) Enter the currency exchange rate, such as: "1EUR = xx.xxxx USD". Press the
step.
6) Enter the currency parameters as shown in figure 3.22 and set the value using the
After programming of all values, a message showing the status of the third Euro phase setting will appear
on the display and will also be printed out on an informational receipt:
Euro steg
3
INHEMSK VALUTA
UTL. VALUTA
Valutakurs
1 EUR = 10.4700 SEK
Valuta flag
------------------------------
------------------------------
Växlingskurs
1EUR=10.4735 SEK
Dubbel visning
During the third Euro phase, the parameters can be set by following this procedure:
1) Switch into programming mode by pressing the key combination

2) Press the key.
3) Enter the currency code and press
4) Enter the exchange rate regarding the new main currency and press
5) Enter the currency parameters per figure 3.22 and confirm the setting by pressing
Notice:
he name and parameter of the foreign currency can be changed after the execution of a monthly Z report
and the value of the exchange rate can be changed after a daily Z report.

ENTERING TEXTS INTO THE ELECTRONIC CASH REGISTER

The numerical keys are used in text programming (logo, PLU names, cashiers names etc.). There are num-
bers in the upper part of the keys and letters and other characters are in the lower part. In national versions,
all letters and characters of the alphabet are on the keys. To enter a capital letter press the
and press the relevant key. For instance, enter letter "a" by simply pressing the

and pressing the

character press .
Characters that are not printed on the keys are „ '" (2 ×
 
× ), „ ? " (7 × ) a „ $ " (8 ×
If you want to print a double-spaced character, press the
The double-width character is displayed as character with space in front on the cash register display. If the
programmed text string has characters which are on the same key, press the particular key as needed, wait
until a full character appears on the display, and then press the key again. If there are successive characters
.
EUR
USD
022
av


key three times, number "5" by pressing the

).
.

), „ ; " (3 ×

Programming manual

ey to go to the next

.

.


key, letter "F" by holding

key four times, to get the space
 
), „ < " (4 × ), „ > " (5 ×
key before each double-width character.

key.
.

(S ) key
HIFT

), „ = " (6
53