Components (Rear); Figure 1.36 I/O Module (2.5"/3.5" Type Drive Enclosure); Table 1.9 Status And Meanings Of Each Led (I/O Module (2.5"/3.5" Type Drive Enclosure)) - Fujitsu ETERNUS DX100 S4 Basic Operation Manual

Hybrid
Hide thumbs Also See for ETERNUS DX100 S4:
Table of Contents

Advertisement

Chapter 1
Component Names and LED Names
1.2
2.5"/3.5" Type Drive Enclosures
1.2.4

Components (Rear)

This section describes the I/O modules and the power supply units in the rear of the drive enclosure.
I/O Modules
The I/O module is a component that controls how the controller and the drives interact.
Figure 1.36
shows the I/O module.

Figure 1.36 I/O Module (2.5"/3.5" Type Drive Enclosure)

2 3
1.
DI (IN) port
This port is used to connect between enclosures.
2.
DI (IN) LINK LED
3.
DI (IN) FAULT LED
4.
DI (OUT) port
This port is used to connect between enclosures.
5.
DI (OUT) LINK LED
6.
DI (OUT) FAULT LED
7.
READY LED
8.
IDENTIFY LED
9.
FAULT LED
The LEDs turn on or blink to indicate the statuses that are listed below.

Table 1.9 Status and Meanings of Each LED (I/O Module (2.5"/3.5" Type Drive Enclosure))

LED name
DI (IN) LINK
DI (IN) FAULT
DI (OUT) LINK
DI (OUT) FAULT
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Table 1.9
1
4
5 6
LED status
(green)
(amber)
(blinks amber)
(green)
(amber)
(blinks amber)
Copyright 2017 FUJITSU LIMITED
shows the status and meanings of each LED.
Meaning
The link between the DI (IN) port and the source port has been
established.
The ports to remove the mini SAS HD cables between enclo-
sures from are indicated. This occurs while a drive enclosure is
being added.
The link between the DI (IN) port and the source port is in error
status.
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
The link between the DI (OUT) port and the destination port has
been established.
The link between the DI (OUT) port and the destination port is in
error status.
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
39
7
8
9
P3AM-7662-09ENZ0

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eternus dx200 s4Eternus dx100 s3Eternus dx200 s3

Table of Contents