Endpoint Test Status - HP ProCurve NAC 800 User Manual

Endpoint Activity

Endpoint Test Status

TIP:
4-10

Endpoint Test Status

NAC 800 provides on-going feedback on the test status of endpoints in the left
pane of the Endpoint activity window as follows:
To view access status, see "Viewing Endpoint Access Status" on page 4-16.
■ Failed – NAC 800 shows this status after the endpoint has failed
testing. Click on the plus (+) symbol to show the test failed categories.
Passed – NAC 800 shows this status after the endpoint has passed the
■
test and is connected to the network.
■ Not tested – NAC 800 shows this status when a device cannot be
tested.
Connecting – NAC 800 shows this status briefly after the endpoint has
■
been tested while the endpoint is being assigned a non-quarantined
IP address.
If you hover the mouse cursor over the icons in the Endpoint activity window,
you will get additional information about the status of the endpoint.
Figure 4-7. Endpoint Mouseover Pop-up Window
The following lists the possible test statuses:
■ Unknown error – This is most likely a problem that cannot be resolved
without contacting ProCurve. Try to force a retest from the NAC 800
user interface. If that does not work, call ProCurve Networking by HP
and be prepared to generate a support package (see "Generating a
Support Package" on page 15-17).