Hp Procurve 3400/3500/5400; Nortel® 5510 - HP ProCurve NAC 800 User Manual

Hide thumbs Also See for ProCurve NAC 800:
Table of Contents

Advertisement

802.1X Quarantine Method
Setting up the 802.1X Components
ProCurve Access Point 530(radio1-wlan1)#wep-key-ascii
ProCurve Access Point 530(radio1-wlan1)#wep-key-1 1q2w3e4r5t6y7
ProCurve Access Point 530(radio1-wlan1)#write mem
ProCurve Access Point 530(radio1-wlan1)#enable
ProCurve Access Point 530(radio2-wlan1)#enable
ProCurve Access Point 530(config)#radio 1
ProCurve Access Point 530(radio1)#enable
ProCurve Access Point 530(radio1)#radio 2
ProCurve Access Point 530(radio2)#enable
ProCurve Access Point 530(config)#write mem
ProCurve Access Point 530(config)#exit

HP ProCurve 3400/3500/5400

radius-server host 10.60.1.3 key hpsecret
aaa accounting network start-stop radius
aaa authentication port-access eap-radius
aaa port-access authenticator 1-8
aaa port-access authenticator 1-8 auth-vid 100
aaa port-access authenticator 1-8 unauth-vid 101
aaa port-access authenticator active
Nortel® 5510
NOTE:
RADIUS Server setup:
radius-server host 10.0.0.5
radius-server secondary-host 0.0.0.0
radius-server port 1812
! radius-server key ********
Enable 802.1X:
eapol enable
interface FastEthernet ALL
eapol port 1-2 status auto traffic-control in-out re-
authentication enable re-a
11-56
When the Nortel switch is used in unstacked mode, a range of ports is defined
as 1-24.
When the Nortel switch is used in stacked mode, a range of ports is defined
as 1/1-24; <unit>/<port-port>. See the Nortel switch user manuals for more
information.

Advertisement

Table of Contents
loading

Table of Contents