Status Leds - HP MSM720 Quick Start Manual

MSM720 Controllers Quickstart
Horizontal surface installation
Attach the supplied rubber feet to the four corners on the bottom of the
controller within the embossed angled lines. Place the controller on a table or
other sturdy horizontal surface in an uncluttered area. Secure the networking
cables and power cord to a table leg or other part of the surface structure.
LEDs

Status LEDs

LED State Meaning
Power On The controller is powered on.
(green)
Off The controller is not receiving power.
Fault On The controller is beginning its boot
(orange) sequence.
On for three seconds at power up or
reset.
Locator On The
services <slot-id>
(blue)
locator on
assist in finding the module.
Flashing The
services <slot-id>
locator blink
issued to assist in finding the module.
Off Default state. Otherwise, the
<slot-id> locator off
was issued or a previous flash request
has timed out.
Test Flashing The SSD is active.
(green)
Off The SSD is not active.
command was issued to
command was
services
command
4
Port LEDs
The SFP slots are shared with 10/100/1000 Base-T RJ-45 ports. When an SFP
transceiver is installed in a slot, the associated RJ-45 port is disabled and
cannot be used.
LED State Meaning
RJ-45 ports
Link (green) On The port is enabled and linked to the
connected device.
Off One of these condition exists:
• No active network cable is connected to
the port
• The port is not receiving a link
indication or sufficient light
• The port has been disabled through the
controller console, the web browser
interface, HP Manager, or other network
management tool
Mode (green) Indicates Activity, Duplex, or Speed
according to Mode selected.
SFP ports
Link (green) Flashing •
•
For a list of supported SFPs see the
MSM720 Controllers Installation Guide.
Link and On for 2 Both Link and Mode turn on for two
Mode (green) seconds seconds and then go into operational
state to indicate that the controller
recognizes the SFP transceiver.
The software does not support the
SFP transceiver
The controller does not support this
SFP transceiver
LEDs