HP ProCurve NAC 800 User Manual page 463

g. Restart the network interface by entering the following at the
command line:
service network restart
2. Change the interface the EDAC listens on:
a. Log in to the MS using SSH or directly with a keyboard.
b. For 802.1X mode, enter the following command at the command line:
setProperty.py -c
Compliance.ObjectManager.NACModeTcpdumpInterface=
eth1.1
3. Verify the change:
a. Log in to each ES using SSH or directly with a keyboard.
b. Enter the following command at the command line:
ifconfig
c. Verify that the virtual interface you created is listed.
d. Open the following file:
/var/log/nac/nac-es.log
e. Verify that the EDAC is using the virtual interface you created. The
log should contain a line similar to the following:
[070509-MDT 10:53:11.366 DeviceActivityCapture-
INFO ] Listening on: eth1.1
<cluster name>
System Administration
VLAN Tagging
15-35