Table 3-1 Thermostat Status Field Descriptions; Figure - Proliphix NT10e Configuration Manual

CHAPTER 3: Configuring the Thermostat Using the TMI
Use
Settings, and Alarm Status fields.

Table 3-1 Thermostat Status Field Descriptions

Field
Temperature
Zone Temperature
Override
Cool Setting
Heat Setting
Hold Mode
Schedule Settings
Day Class / Period
Cool
3-10
Table 3-1 to configure the Temperature status, Schedule Settings, HVAC
Description
Displays the current temperature of the local sensor if temperature averaging
is disabled.
Average temperature of any combination of Local, Remote Sensor #1 (RS
#1) or Remote Sensor #2 (RS #2) if temperature averaging is enabled. (See
Advanced Settings Page (page
In a range of -30
Displays whether Heat or Cool Settings are different from the current
scheduled settings. Changes made to either the Heat or Cool Settings
(which force an override) remain at those settings until the next scheduled
Period change. At the Period change, the settings for either/both heat or cool
follow the schedule. (See
Override
Displays the current temperature programmed for the cooling (A/C) system.
This field is disabled if the HVAC mode is set to Heat or Off. (See
Mode (page
be a heat-only controlling device. (See
To modify this field, use the drop-down menu to select a Cool Setting.
°
40 F(4.5
Displays the current temperature programmed for the heating system. This
field is disabled if the HVAC mode is set to Cool or Off. (See
(page 3-11).) This field is not visible if the thermostat is configured to be a
cool-only controlling device. (See
To modify this field, use the drop-down menu to select a Heat Setting.
°
40 F(4.5
Displays the current state for both the Heat and Cool Setting. To "hold" the
current settings indefinitely or for a prescribed period of time as set on the
Advanced Settings Page (page
Hold – Hold mode is enabled.
Off (default) – Hold mode is disabled.
Displays the current settings for both the scheduled Day Class and Period.
Day Class – Occupied, Unoccupied, and Other
Period – Morn(ing), Day, Eve(ning), Night
Displays the current Cool temperature setting as set within the current Day
Class schedule. (See
°
40 F(4.5
Basic Series Network Thermostat Configuration Guide, Release 3.0
Beta Draft Confidential
3-30).)
° ° °
F(-34 C) to 199 F(95
Schedule Settings (page
3-11).) This field is not visible if the thermostat is configured to
° ° °
C) to 99 F(37 C)
Advanced Settings Page (page
° ° °
C) to 99 F(37 C)
3-30), use the drop-down menu and choose
Setback Schedules Page (page
° ° °
C) to 99 F(37 C)
°
C)
3-10).)
HVAC
Advanced Settings Page (page
HVAC Mode
3-30).)
3-17).)
Part No. 600-01000-201, Rev. 1
3-30).)