Table 2-6 Thermostat Status Screen Options; Figure - Proliphix NT10e Configuration Manual

Beta Draft Confidential
Use

Table 2-6 Thermostat Status Screen Options

Field
Reset
Type
See the
HVAC Type
Basic Series Network Thermostat Configuration Guide, Release 3.0
Part No. 600-01000-201, Rev. 1
Table 2-6 to configure the Thermostat Status screen options.
Description
Press and hold the Reset button for three (3) seconds to perform a software reboot.
Select either Fuel Burner (default) or Heat Pump. When selecting between either
Fuel Burner or Heat Pump or between Heat Pump and Fuel Burner, the HVAC
Mode must be set to OFF prior to selecting the opposite setting. (See
HVAC Setting (page 2-7)
Fuel Burner – Fossil fuel systems which includes oil or gas-fired boilers or
furnaces.
Heat Pump – Electric heat pump HVAC system type.
Advanced Settings Page (page 3-30)
Displays the selected HVAC system type; Fuel Burner or Heat Pump.
Fuel Burner:
Heat Ctrl:
Disable – No heating system is present.
Enable – Heating is enabled.
Cool Ctrl:
Disable – No cooling system is present.
Enable – Cooling is enabled.
Heat Pump:
Heat Ctrl:
Disable – No heating system is present (i.e. air conditioning only)
Enabled - Heating is enabled.
Aux Heat – Auxiliary heat is enabled to augment the heat pump.
Cool Ctrl:
Disable – No cooling system is present (i.e. heat only)
Enabled – Heating is enabled.
or Status & Control Page (page
further explanation of the following parameters.
Thermostat Screen
Changing the
3-9).
2-11