Figure; Table - Proliphix NT10e Configuration Manual

Beta Draft Confidential
Table 3-1 Thermostat Status Field Descriptions (Continued)
Field
Heat
HVAC Settings
HVAC State
HVAC Mode
Fan Relay State
Fan Mode
Alarm Status
Low Temperature
Basic Series Network Thermostat Configuration Guide, Release 3.0
Part No. 600-01000-201, Rev. 1
Description
Displays the current Heat temperature setting as set within the current Day
Class schedule. (See Setback Schedules Page (page
° ° ° °
40 F(4.5 C) to 99 F(37 C)
Displays the current state of the heating or cooling system. If a state change
is made while viewing this page, click Refresh to update the status.
Heat – Heating system is actively heating.
Aux Ht – Heating system and auxiliary heat are actively heating. (Heat
Pump only)
Cool – Cooling system is actively cooling.
Off – Neither the heating system or cooling system is active (i.e. on).
Displays and controls the current mode setting for the HVAC system. The
thermostat can be configured to control the heat system only, cool system
only, automatically change over between heating and cooling systems, or
control neither system.
Off – The thermostat is disabled from controlling either the heating or
cooling system.
Heat – Heating system only.
Cool – Cooling system only.
Auto – Automatic changeover between heating and cooling systems.
Displays the current state of the HVAC fan.
Off – The operation of the fan is off.
On – The fan is operating.
Displays and controls the current state setting for the HVAC fan.
Auto – Heating or cooling system controls the operation of the fan.
On – User forces the fan to the on state independent of the operation of
the HVAC system.
Displays the current status of the Low Temperature alarm condition. The
temperature has fallen below a pre-programmed limit. After this alarm
occurs, you must repair the condition which caused the temperature to fall
below the configured limit before resetting this alarm. (See
Page (page 3-13).)
OK – No Low Temperature alarm exists.
Alert! – The temperature monitored within the thermostat has dropped
below the pre-set low temperature threshold.
Status & Control Page
3-17).)
General Settings
3-11