Troubleshooting; Resetting The Thermostat; Software Reset - Proliphix NT10e Configuration Manual

Beta Draft Confidential

Troubleshooting

This chapter describes how to reset the Proliphix thermostat.

Resetting the Thermostat

Although it is highly unlikely that the thermostats are unable to perform correctly
against unsolicited and unwanted network activity, occasionally a reset may be
necessary to bring the thermostat back into proper operation.
Do not perform a software reset or factory reset on the thermostat until instructed
to do so by a qualified Proliphix customer support representative. See
Caution
Support

Software Reset

A software reset reboots the network processor and retains the programming and
thermostat setback schedules.
To perform a software reset at the thermostat:
From the
1
2-10).
Press and hold Reset for longer than 3 seconds (see
2
Basic Series Network Thermostat Configuration Guide, Release 3.0
Part No. 600-01000-201, Rev. 1
on page xv.
Status & Control Screen (page
Chapter
2-9), select Thermostat Control Screen (page
Figure 2-8 on page
4
Technical
2-10).
4-1