Figure; Table - Proliphix NT10e Configuration Manual

Beta Draft Confidential
Table 2-2 Thermostat Screen Options (Continued)
Field
Cool Setpoint Temperature
Time
Temperature Hold
HVAC Activity
HVAC Mode Control
Next
Period State
Basic Series Network Thermostat Configuration Guide, Release 3.0
Part No. 600-01000-201, Rev. 1
Description
Indicates the current cool setpoint temperature (
defined by the thermostat schedule.
Note: This field is disabled if only Heat is selected in HVAC
mode. This field is not be visible if the thermostat is configured as
a heat-only thermostat.
Time of day displayed in Daylight Savings Time if chosen.
Holds current temperature either permanently or for 1, 3, 8, 12, or
24 hours or until after you manually remove the Hold, after which
the temperature settings "Return" to that set in the schedule. The
Hold button toggles between Hold and Return. (See
Settings Page on page 3-30)
Displays the current state of the HVAC system. For either Fuel
Burner or Heat Pump, the LCD displays the following:
Delay – Compressor delay is active (Heat Pump and Fuel
Burner A/C)
Heat – Heating is active.
Aux Ht – Auxiliary heat is active (Heat Pump only).
Cool – Cooling is active.
Enables the HVAC screen whereby HVAC and Fan settings can
be modified (see

Figure

2-4).
Enables display of the next thermostat screen.
Displays the current scheduled Period. The four schedule Periods
are Morn, Day, Eve(ning) and Night.
Thermostat Screen
o o
F or C) as
Advanced
2-5