Verifying The Thermostat's Operating Status; Testing The Heat Controls - Proliphix Thermostat Installation Manual

Beta Draft Confidential
Figure 5 Thermostat Jumper Locations
Prior to mounting the thermostat into the base plate, verify that the jumpers on the
thermostat are configured for your application (see
To mount the thermostat into the base plate:
Mount the thermostat into the base plate (see
1
into the corresponding receptacle holes in the top of the base plate.
Snap the bottom of the thermostat securely into the base plate.
2

Verifying the Thermostat's Operating Status

This section describes the procedures you can use to verify that the heat, cool, and fan
controls are operating properly on your thermostat. Before you begin, verify that the
HVAC system's power is set to "On" and press HVAC on the thermostat panel.

Testing the Heat Controls

Press HVAC.
1
Press Mode. A menu list appears.
2
Use the Up and Down arrows on the right side of the panel to select Heat.
3
Press Select.
4
Press Back.
5
Continuously press the Up arrow until the heat set point is higher than the temperature
6
reading. The heat relay should click and the HVAC system should activate the heat.
Proliphix Thermostat Installation Guide, Release 1.0
Part No. 600-01000-100
J3
Installing and Wiring the Thermostat
Table 5).
page 3) by inserting the top two hinges
11