Table 3-6 Advanced Settings Fields - Hvac Fuel Burner Field Descriptions - Proliphix NT10e Configuration Manual

CHAPTER 3: Configuring the Thermostat Using the TMI
Use

Table 3-6 Advanced Settings Fields - HVAC Fuel Burner Field Descriptions

Field
HVAC System Type
If Your HVAC System is a Fuel Burner
Heat Control
Cool Control
If Your HVAC System is a Heat Pump
Heat Control
3-32
Table 3-6 to configure the Advanced Settings for a parameters.
Basic Series Network Thermostat Configuration Guide, Release 3.0
Beta Draft Confidential
Description
Select the type of HVAC system, either Fuel Burner (default) or
Heat Pump HVAC systems as follows:
Fuel Burner (default) – The HVAC system burns fossil
fuels (e.g. gas or oil). Typically the system includes either an
oil or gas fired boiler or furnace. See
page 3-31 and continue with
Burner (page 3-32).
Heat Pump – Specifies that the HVAC system is based on
an electric compressor. See
continue with If Your HVAC System is a Heat Pump (page
3-32).
Note: When selecting between either Fuel Burner or Heat
Pump or between Heat Pump and Fuel Burner, the HVAC
Mode must be set to Off prior to selecting the opposite setting.
See the Status & Control Page (page
Select the HVAC control for this thermostat. This parameter
describes the thermostat capability to control a fuel burner
heating system. The thermostat can also be disabled from
controlling a heating system and instead operate as a cool-only
thermostat. (See Cool Control (page
Disable – No heating system exists. (A/C only thermostat.)
Enable – Enables the heating system.
Specify the HVAC control of this thermostat. This parameter
describes the thermostat's capability to control a fuel burner
cooling system. The thermostat can also be disabled from
controlling a cooling system and instead operate as a heat-only
thermostat. (See Heat Control (page
Disable – Specifies that there is no cooling system present.
(heat-only thermostat)
Enable – Enables the cooling system.
Specifies the HVAC control of this thermostat. This parameter
describes the thermostat's capability to control a heat pump
system. The thermostat can also be disabled from controlling a
heating system and instead operate as a cool-only thermostat.
(See Cool Control (page 3-33).)
Disable – Specifies that there is no heating system present.
(A/C only thermostat)
Enable – Enables the heating system.
Part No. 600-01000-201, Rev. 1
Figure 3-15 on
If Your HVAC System is a Fuel
Figure 3-14 on page 3-30 and
3-9).
3-32).)
3-32).)