Figure - Proliphix NT10e Configuration Manual

Beta Draft Confidential
Table 3-2 General Settings Field Descriptions (Continued)
Field
Low Temp(erature) Dismiss
High Temp(erature) Limit
High Temp(erature) Dismiss
Filter (change) Reminder
Basic Series Network Thermostat Configuration Guide, Release 3.0
Part No. 600-01000-201, Rev. 1
Description
If a Low Temp Limit alarm is pending, you must clear this
condition. In Figure 3-4 on page
is set and is noted in the Low Temp Dismiss field. Note that the
Condition Repaired box must be checked and the
Temperature must be above the Low Temp Limit or the Low
Temp Limit must be set to Disable for the alarm condition to be
cleared upon a Submit.
Disable (default) – No low temperature limit is set.
o o o
-30 F(-34.5 C) to 200 F(93
Select a value or Disable to indicate the high temperature
threshold detection status. The value set by this parameter is
monitored by the thermostat and compared against the current
Zone Temperature. If the current
this value, an alarm condition is set and the status is displayed on
the Status & Control Page (page
sent to the Proliphix web site to trigger an email notification if
this function is Enabled.
Disable (default) – No high temperature limit is set.
° ° °
-30 F(-34.5 C) to 200 F(93
This is a major (red) alarm condition. (See
page 3-13.)
If a High Temp Limit alarm is pending, you must clear this
condition. In Figure 3-4 on page
alarm is set and is noted in the High Temp Dismiss field. Note
that the Condition Repaired box must be checked and the
Temperature must be below the High Temp Limit or the High
Temp Limit must be set to Disable for the alarm condition to be
cleared upon a Submit.
Disable (default) – No low temperature limit is set.
o o o
-30 F(-34.5 C) to 200 F(93
Select an interval between Disable (default) and 365 days to
remind you that the HVAC system requires maintenance. This
feature allows you to set time intervals between changing and/or
cleaning the HVAC filter. If enabled, an alarm condition is set
after the pre-set interval has expired, and is displayed on the
Status & Control Page (page
to the Proliphix web site to trigger an email notification if this
function is Enabled.
This is a minor (yellow) alarm condition.
Disable (default) – Interval reminder disabled.
10, 30, 60, 90, 120, 240, 365 Runtime Days – The runtime
interval after which an alarm will be set to remind the user of
the need for HVAC maintenance.
General Settings Page
3-13, a Low Temp Limit alarm
Zone
o
C)
Zone Temperature rises above
3-9). In addition, this alarm is
°
C)
Figure 3-4 on
3-13, a High Temp Limit
o
C)
3-9). In addition, this alarm is sent
Zone
3-15