Sensor Status Screen; Table 2-4 Sensor Status Screen Options; Figure - Proliphix NT10e Configuration Manual

CHAPTER 2: Configuring the Thermostat Using the TDI

Sensor Status Screen

The Sensor Status screen is a secondary screen on the Basic series models (if remote
sensors are installed and enabled) and the second primary screen if remote sensors are
disabled.
The NT10e does not support external thermal sensors, therefore this screen is not
available on the NT10e Network Thermostat.
Note
Figure 2-6 Sensor Status Screen
Table 2-4

Table 2-4 Sensor Status Screen Options

Field
Zone Average
Local
East Entry (e.g. RS #1)
West Entry (e.g. RS #2)
2-8
Sensor Status
Zone Average
Local
Family Room
Dining Room
Prev
lists the sensor status screen display options.
Basic Series Network Thermostat Configuration Guide, Release 3.0
Beta Draft Confidential
72.6
Cool
72.3
71.6
73.9
Next
Displays
Average temperature of any combination of Local, Remote
Sensor #1 (e.g. East Entry), and Remote Sensor #2 (e.g. West
Entry).
Current temperature of the sensor within the thermostat.
Current temperature of Remote Sensor #1.
Current temperature of Remote Sensor #2.
Part No. 600-01000-201, Rev. 1