Remote Access Page; Remote Server Configuration - Proliphix NT10e Configuration Manual

CHAPTER 3: Configuring the Thermostat Using the TMI

Remote Access Page

From the Remote Access page, you can configure parameters necessary to invoke and
control the intercommunication of the thermostat with a remote server (e.g. Proliphix
Web Site) for remote access. Note that when this service is enabled (i.e. Remote
Access is enabled, see below) all alarm notifications are sent to the Proliphix Web
Server IP address for processing and subsequent transmission as an e-mail.

Remote Server Configuration

You can access the Proliphix Network Thermostats remotely from anywhere in the
world using a web browser. By default, Proliphix thermostats intercommunicate with
the Proliphix Web Server to provide this capability. If the Proliphix Web Server is not
used, a private server may be used but it must provide both alarm notification
processing and e-mail generation to fully emulate the remote-access capability which
Proliphix provides. Certain parameters must be configured in this section to facilitate
the remote access feature.
Figure 3-17 Remote Access Page
3-38
Beta Draft Confidential
Basic Series Network Thermostat Configuration Guide, Release 3.0
Part No. 600-01000-201, Rev. 1