Verifying The Thermostat's Operating Status; Logging In To The Thermostat - Proliphix IMT Series Installation Manual

Logging In to the Thermostat

Verifying the Thermostat's Operating Status

This section describes the procedures you can use to verify that the heat, cool, and fan
controls are operating properly on your thermostat. Before you begin, verify that the
HVAC system's power is set to "On" and HVAC on the thermostat lcd panel is set to
"Auto".
Testing the Heat Controls
Verify the HVAC mode is set to either Auto or Heat.
1
Continuously press the Up arrow until the heat set point is higher than the temperature
2
reading.
A flame icon appears, and the HVAC system activates the heat.
Testing the Cool Controls
Verify the HVAC mode is set to either Auto or Cool.
1
Continuously press the Down arrow until the cool set point is lower than the
2
temperature reading.
A snowflake and fan icon appears, and the HVAC system activates the cool and fan.
Testing the Fan Operation
Press the fan button until the mode is set to On. A fan icon appears, and the fan circuit
is now active.
Logging In to the Thermostat
Log in to the TMI as the Administrator as follows:
Enter the username: admin.
1
Enter the password: admin (default).
2
14
Beta Draft Confidential
Proliphix Internet Managed Thermostat (IMT) Installation Guide, Release 1.0
Part No. 600-03100-000, Rev. 2