Installing The Thermostat; Required Tools; Installation Guidelines - Proliphix IMT350c Installation Manual

Beta Draft Confidential
The advantage of this method is that it can provide power to the thermostat when you
are not able to provide a Common in addition to your existing wiring if you have a fan
control wire (G). The disadvantage to this method is that you will lose independent
control of your fan meaning you will not be able to turn the fan on or off without
turning on your air conditioning.
Installing an HPA should be done only by a qualified professional. Please consult
with your HVAC technician or your local electrician for further assistance.
Note

Installing the Thermostat

This section describes the required tools, guidelines, and installation instructions for
the IMT350.
Preventing electrostatic discharge (ESD) — Static electricity may cause damage
to the components on the thermostat's circuit module. Do not remove the
Caution
thermostat from the protective bag until you are ready to install the thermostat.

Required Tools

The following tools are required to install the Proliphix thermostat:
#1 or #2 Phillips head screwdriver.
Drill with a 3/16" or 7/32" bit.
Terminal block screw driver (included with the thermostat).

Installation Guidelines

Use the following guidelines to install the IMT350:
If you are replacing an existing thermostat, mount the thermostat in the same
location as the thermostat in which you are replacing.
Tip
Install the thermostat on an inside wall, about 5 feet (1.5m) above the floor, and in
a room that is used often.
Install the CAT5/CAT5E/CAT6 cabling from the wiring center to the thermostat
installation site for model IMT350c. This is not required for the IMT350w model
(802.11 b/g wireless).
Proliphix Internet Managed Thermostat (IMT) 350c/350w Installation Guide, Release 1.0
Part No. 600-03000-350, Rev. 1
Installing the Thermostat
3