Table of Contents
Advertisement
Each area can be controlled individually as if they were
separate alarm systems.
All On
When you turn an area All On, you are turning on all non 24-
hour zones, both interior (motion detectors) and perimeter
(doors and windows) of the building.
Part On
When you turn an area Part On, you only turn on some of the
non 24-hour zones. Your security company will program
which zones are included in this mode. Part zones may
include only the perimeter (doors and windows) of your
system, or sensors in other areas of your premises. Check
with your security company to learn which zones are Part
zones.
Re por t i ng Al a rm s
Your system may be programmed to send reports and
it does this over a working IP connection either through
Ethernet, WiFi or through a cellular radio module depending
on your installation (check with your security company).
Your system makes repeated attempts to send reports to
your security company. If your system fails to report, the
keypad will display the 'service' symbol.
Abo ut t h e Key p ad
Your keypad has 20 keys or buttons. The buttons allow you
to input instructions and navigate the menu screens as
required. Some buttons have a secondary function which
is activated by holding them down for two seconds.
Each button's function is described below:
Keypad Keys
Key
The numeric keys allow you to enter
to
you numbers when required.
Use the [MENU] and the numeric keys
to enter commands. The [MENU] key
is also used to go back one level when
navigating through menus or to exit a
programming location without saving
changes.
The [ON] key allows you to turn an area
or output on. If your system has been
partitioned press and hold the [ON]
key for two seconds to turn all areas on
at the same time.
The [PART] key allows you to turn an
area Part On. This key can also be used
to bypass a zone or multiple zones
when you press and hold for two
seconds.
Bosch Security Systems 10/22 BLCC615U
Description
Key
The [OFF] key allows you to turn an
area or output off. If your system has
been partitioned press and hold the
[OFF] key for two seconds to disarm to
disarm all areas.
The [OK] key allows you to save any
changes and exit the command.
The [MAIL] key allows you to read
stored mail. This key can also be used
to a test report when you press and
hold for two seconds.
The [] key allows you to move the
cursor left when programming text.
The [] key allows you to move the
cursor right when programming text.
The [] key allows you to navigate
through menus or to toggle characters.
The [] key allows you to navigate
through menus or to toggle characters.
Pressing The [] key will display current
trouble conditions when the area that
the keypad is displaying is disarmed.
Pressing the [] and [] keys together
and holding them down for 2 seconds
+
will cause a Panic alarm to be triggered.
If programmed the sirens will sound
for 2 sec
and the monitoring station will be
notified.
Pressing the [] and [] keys together
+
and holding them down for 2 seconds
will cause a Fire alarm to be triggered. If
for 2 sec
programmed the sirens will sound and
the monitoring station will be notified.
Pressing the [] and [] keys together
and holding them down for 2 seconds
+
will cause a Medical alarm to be
triggered. If programmed the sirens
for 2 sec
will sound and the monitoring station
will be notified.
Table 2: Keypad Keys and Their Function
Figure 1: Keypad Emergency Alarm Triggers
Solution 6000-IP
User Guide
Description
7
Advertisement
Table of Contents
