Burglary Alarms - Bosch Security System User Manual

Burglary Alarms

Burglary alarms are the second priority. When a
burglary point activates while your system is armed,
your command center emits a steady high-pitched
burglary tone. The tone sounds for the time set by your
security company.
The command center display shows the number of
burglary points activated, the message "Enter Passcode
+ ENTER key to Silence" and then custom text for each
activated point
If there is more than one point causing an alarm, the
display will show each point for three seconds before
showing the next one. When the last alarm is shown,
the next display is the first one.
Silencing Burglary Alarms
Entering a personal passcode with the proper authority
level silences a burglary alarm and disarms the system if
it was armed.
4998122475C
The system will now display *Alarm Silenced* and then
the number of points in alarm (### ALARMS) and the
custom text of all the points in alarm, in the order of
occurrence will display.
Entering COMMAND 4 clears the scrolling point text
from the display.
The *Alarm Silenced* message will continue to
alternate with idle text as a reminder that it is still
possible to view the text of the points in alarm by using
the View Memory function. See VIEW MEMORY ?
(Command 40) for more information.
To clear the event memory and remove the *Alarm
Silenced* message from the display, press the Clear
Display> soft key.
The display will show the instructions for clearing the
message. Enter a valid passcode and press the Clear>
soft key.
Security System User's Guide
Part I: Security System Basics
Burglary Alarms