Chapter 3: Installing Optional Hardware Features 3-19
How to Install the Compact Flash Card (Type 1 or Type 2)
Caution: Before installing or removing a Compact Flash Card, turn off the
power. The workstation does not recognize any compact flash card when the
card is installed while the workstation is powered on. In worst case, any data in
a compact flash card is destroyed or permanent damage may occur.
The following figure shows how to install the Compact Flash Card into the
Compact Flash Disk I/F board. If the installed card is not recognized correctly,
check the Jumper(J4) on the Compact Flash I/F Board. (Refer to How to install
the Compact Flash I/F Board)