NCR 7448 Network Boot Setting with LCD Operator Display
See Keys Used in the Crisis Recovery, BIOS Setup, and BIOS Upgrade in
Appendix A: BIOS.
1.
Turn on the NCR 7448 Workstation power. The workstation displays the
NCR logo.
Caution: Power up the workstations at an interval of at least five seconds if you
are going to turn on more than one workstation.
2.
If the NCR 7448 Workstation installs two or more disks(e.g. Flash and
Hard disks), go to Step 3. If not, go to Step 8.
3.
Press ESC key when the boot manager displays the followings:
PXE-M00: BootManage UNDI, PXE-2.0 (build XXX)
PXE-M00: Initializing: PnP/BEV
PXE-M04: Hold down both shift keys to change bootstrap
selection...
In the boot menu below, select <Enter Setup> by using the Down Arrow key.
1.
Diskette Drive
2. +Hard Drive
3.
BootManage UNDI, PXE-2.0 (build XXX)
<Enter Setup>
Chapter 5: Crisis Recovery 5-35
Boot Menu