How To Install The International Vfd Customer Display; Integrated Mount International Vfd Customer Display (Low Profile/ Telescope) - NCR 7448 Hardware User's Manual

3-4 Chapter 3: Installing Optional Hardware Features

How to Install the International VFD Customer Display

Integrated Mount International VFD Customer Display (Low
Profile/ Telescope)
Caution: Do not connect the VFD to a power source that is already powered on.
1. Remove the Integrated Display Bracket from the back of the International
VFD Customer Display Cabinet.
2. Route the display cable through the Telescope Mount, the Low Profile
Mount and the Integrated Display Swivel.
3. Connect the display cable to the International VFD Customer Display
4. Remove the Escutcheon on the upper cabinet.
5. Install the International VFD Customer Display assembly into the upper
cabinet.
6. Connect the display cable to the RS232 port on the workstation.*
* Note: Cable Routing procedure for 7448 workstation -Hard disk
model
1. Lay the 7448 workstation on its side.