Enter Setup - NCR 7448 Hardware User's Manual

After power LED turned off, turn on the NCR 7448 Workstation by pressing
power switch.
4. Enter PXE PROM Boot
Press the ESC key 10-12 seconds after pressing power switch. (See Note*4)
Note*4: If you press the ESC key too early (or too late) you will not go on to Boot Menu.
In this case, turn off the NCR 7448 Workstation and start over again.
5. Perform PXE PROM Boot
Wait at least 20-25 seconds. You are now at the Boot Menu, which is still a
blind operation for 2x20 Operator Displays. To make sure that the Boot Menu
has the multiple boot options, see the sample diagram illustrated below. (See
Note*4)
1. Diskette Drive
2. +Hard Drive
3. BootManage UNDI, PXE-2.0 (build XXX)
<Enter Setup>
To perform PXE PROM Boot, follow the procedures below.
1. Press the Up Arrow key 4 times (just to make sure you are starting from
the top).
2. Press the Down Arrow key twice to select PXE PROM Boot menu (See
Note*5).
3. Press the Enter Key to perform the PXE PROM Boot.
Appendix A: BIOS
Boot Menu
A-19