6.6.2
probe-ide Command
The probe-ide command communicates with all Integrated Drive Electronics (IDE)
devices connected to the IDE bus. This is the internal system bus for media devices
such as the DVD drive.
Caution – If you used the halt command or the Stop-A key sequence to reach the
ok prompt, then issuing the probe-ide command can hang the system.
The following is sample output from the probe-ide command.
CODE EXAMPLE 6-3
{1} ok probe-ide
Device 0
Device 1
Device 2
Device 3
6.6.3
show-devs Command
The show-devs command lists the hardware device paths for each device in the
firmware device tree. The following code example shows sample output from the
show-devs command.
CODE EXAMPLE 6-4
ok show devs
/pci@1d, 700000
/pci@1c,600000
/pci@1e,600000
/pci@1f,700000
/memory-controller@1,0
/SUNW,UltraSPARC-IIIi@1,0
/memory-controller@0,0
6-14
Sun Fire V210 and V240 Servers Administration Guide • December 2005
sample probe-ide Command Output
( Primary Master )
Removable ATAPI Model: DV-28E-B
( Primary Slave )
Not Present
( Secondary Master )
Not Present
( Secondary Slave )
Not Present
show-devs Command Output