Removing And Replacing The Baseboard; Remove And Replace The Baseboard In A Pci Configuration - HP Edgeline EL4000 Maintenance And Service Manual

8. Using a Torx screwdriver, remove the six T-15 screws, and then remove PXIe riser board from the
PXIe riser assembly.

Removing and replacing the baseboard

The following procedures are for both the passthru and switch baseboards.
Perform one of the following procedures depending on the configuration of your system:
• Remove and replace the baseboard in a PCI configuration on page 42
• Remove and replace the baseboard in a PXIe configuration on page 43

Remove and replace the baseboard in a PCI configuration

Procedure
1. Power down the system(Power down the system on page 23).
2. Dismount the system (Dismount the system on page 23).
3. Remove all cartridges (Removing and replacing the cartridge on page 32).
4. Remove the access panel (Removing the PCIe access panel on page 23).
5. Remove the fixed top cover (Removing the fixed top cover of the PCIe system on page 25).
6. Remove the left PCIe riser assembly (Removing the left PCIe riser assembly on page 26).
7. Remove the right PCIe riser assembly (Removing the right PCIe riser assembly on page 27).
8. Do one of the following:
42 Removing and replacing the baseboard
1
2
1
2
1
1
1
1