Table of Contents
Advertisement
13.
Make sure that the heat sink is level.
IMPORTANT:
processor is positioned correctly.
14.
Install the CPU protect cover.
Pass the cable through the cutout on the front of the protective cover. Then, engage the
guides on left and right sides of the cover with the cutout of the server chassis.
15.
Start SETUP and select "Yes" for [Reset Configuration Data] on the Advanced menu.
This setting is required to change the hardware configuration data. See Chapter 4 for
details.
16.
To add one or more processors to the server in 1-processor configuration to operate the
server with more than one processor, do the procedure below:
For Windows Server 2003, change the driver of [Computer] in the device manager to
[ACPI multi-processor PC] and then update the system (see Chapter 5).
If the heat sink is not level, remove it, and check if the
Upgrading Your Server 9-67
Advertisement
Table of Contents
