Table of Contents
Advertisement
3-16 Setting Up Your Server
Removal Procedure
More than one person should remove the server from the rack.
1.
After making sure that the server is off-powered, remove the power cords and all interface
cables from the server.
2.
Release the security lock and remove the front bezel.
Tabs
3.
Remove two screws (A) located at both side of the front face of the server.
4.
Hold the handle to pull out the server from the rack slowly and carefully.
The server clicks to be latched.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages
1-3 to 1-8 for details.
Do not lift the server only by two or less persons.
Do not pinch your finger with mechanical components.
Note high temperature.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
Frame
CAUTION
Unlock
Lock
Advertisement
Table of Contents
