Table of Contents
Advertisement
Error Message for Battery for Onboard RAID Controller
(MegaRAID ROMB)
The battery is charged and discharged when it is replaced or the server is installed. While
performing this cycle, the following error message may appear on POST screen, however, it is not a
problem in operating the system.
Your battery is bad or missing, and you have VDs configured for write-back
mode. Because the battery is not usable, these VDs will actually run in
write-through mode until the battery is replaced.
The following VDs are affected : xx,xx,xx,xx,xx,xx
Following message appears during POST:
The battery hardware is missing or malfunctioning, or the battery is unplugged.
If you continue to boot the system, the battery-backed cache will not function.
Please contact technical support for assistance.
Press 'D' to disable this warning (if your controller does not have a battery).
→ The battery of Onboard RAID Controller (MegaRAID ROMB) may be faulty.
Contact your service representative.
The battery of Onboard RAID Controller (MegaRAID ROMB) is not recognized, or the following
message appears during POST:
Your battery is bad or missing, and you have VDs configured for write-back mode.
Because the battery is not usable, these VDs will actually run in write-through mode
until the battery is replaced.
The following VDs are affected: xx
Press any key to continue.
8 The battery charging rate may be low.
→ Power on the server for several hours to charge battery. After that, check the POST
message again. You can use WebBIOS to check the status on Battery Status screen.
If the battery is still not recognized, the battery may be faulty or dead. The life of
battery is approximately two years. Contact your service representative.
Troubleshooting 8-61
Advertisement
Table of Contents
