Table of Contents
Advertisement
3-14 Setting Up Your Server
NOTE:
to the slide rail assembly with screw (B).
9.
Push the server into the rack once to check the installation position.
To push the server into the rack, lift green release levers at both sides of the rail to unlatch
the server. Pay strict attention to your fingers not to be caught.
IMPORTANT:
Push each release lever using a screwdriver or a similar tool.
Pushing a release lever with your fingers may cause the fingers to
be caught and thus injured.
Two release levers are provided on each side of the rail. Be sure to
use green levers only.
When installing the server into NEC rack, fix the arm stopper
Arm stopper
Viewed from inside
Push the arm stopper in the direction shown
by arrow mark so that the folded portion hits
the end, then fix it with the screw.
Release lever
Advertisement
Table of Contents
