Basic Mode: Network - Bosch VJT-X20XF-E Installation And Operating Manual

VideoJet XF E
Time server type
Select the protocol that is supported by the selected time server. Preferably, you should
select SNTP server as the protocol. This supports a high level of accuracy and is required for
special applications and subsequent function extensions.
Select Time server for a time server that works with the protocol RFC 868.
5.5

Basic Mode: Network

The settings on this page are used to integrate the VideoJet XF E into an existing network.
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
1.
2.
CAUTION!
If you change the IP address, subnet mask, gateway address or the DHCP setting, the
VideoJet XF E is only available under the new addresses after the reboot.
DHCP
If a DHCP server is employed in the network for the dynamic assignment of IP addresses, you
can activate acceptance of IP addresses automatically assigned to the VideoJet XF E.
Certain applications (Bosch Video Client, Bosch Video Management System) use the IP
address for the unique assignment of the unit. If you use these applications, the DHCP server
must support the fixed assignment between IP address and MAC address, and must be
appropriately set up so that, once an IP address is assigned, it is retained each time the
system is rebooted.
IP address
Enter the desired IP address for the VideoJet XF E in this field. The IP address must be valid
for the network.
Subnet mask
Enter the appropriate subnet mask for the selected IP address here.
Gateway address
If you want the unit to establish a connection to a remote location in a different subnet, enter
the IP address of the gateway here. Otherwise leave the box blank (0.0.0.0).
Bosch Sicherheitssysteme GmbH
Make the desired changes.
Click the Set and Reboot button. The VideoJet XF E is rebooted and the changed
settings are activated.
Installation and Operating Manual
Configuration using a Web browser | en
DOC | V5.51 | 2012.03
29