Safety Information; Electric Shock Hazard; Installation And Operation - Bosch VJT-X20XF-E Installation And Operating Manual

VideoJet XF E
2

Safety information

2.1

Electric shock hazard

–
–
–
–
–
–
–
–
2.2

Installation and operation

–
–
–
–
–
Bosch Sicherheitssysteme GmbH
Never attempt to connect the unit to any power network other than the type for which it
is intended.
Use only the power supply provided or power supply units with UL approval and a power
output according to LPS or NEC Class 2.
Never open the housing.
Never open the housing of the power supply unit.
If a fault occurs, disconnect the power supply unit from the power supply and from all
other units.
Install the power supply and the unit only in a dry, weather-protected location.
When installing in a switch cabinet, ensure that the unit and the power supply units have
sufficient grounding.
If safe operation of the unit cannot be ensured, remove it from service and secure it to
prevent unauthorized operation. In such cases, have the unit checked by Bosch Security
Systems.
Safe operation is no longer possible in the following cases:
– if there is visible damage to the unit or power cables,
– if the unit no longer operates correctly,
– if the unit has been exposed to rain or moisture,
– if foreign bodies have penetrated the unit,
– after long storage under adverse conditions, or
– after exposure to extreme stress in transit.
The relevant electrical engineering regulations and guidelines must be complied with at
all times during installation.
Relevant knowledge of network technology is required to install the unit.
Before installing or operating the unit, make sure you have read and understood the
documentation for the other equipment connected to it, such as cameras. The
documentation contains important safety instructions and information about permitted
uses.
Perform only the installation and operation steps described in this manual. Any other
actions may lead to personal injury, damage to property or damage to the equipment.
Please ensure the following installation conditions:
– Do not install the unit close to heaters or other heat sources. Avoid locations
exposed to direct sunlight.
– Allow sufficient space for running cables.
– Ensure that the unit has adequate ventilation. Bear the total heat output in mind,
particularly when installing multiple units in a switch cabinet.
– When making connections, use only the cables supplied or use appropriate cables
immune to electromagnetic interference.
– Position and run all cables so that they are protected from damage, and provide
adequate cable strain relief where needed.
– When installing in a switch cabinet, ensure that the screw joints are free of tension
and subject to as little mechanical stress as possible. Ensure that the unit and the
power supply units have sufficient grounding.
Installation and Operating Manual
Safety information | en 7
DOC | V5.51 | 2012.03